AndoLabInstruments

1ch PZT Driver

How to use

  1. Connect DC power. Default connector is HIROSE 4pin male (as usual) on the back panel. 6-30V DC power is acceptable (15V is desired).
  2. Connect PZT to "OUT" port and apply the control voltage to "IN" port.
  3. Offset is variable by adjusting a potentiometer "OFFSET".
  4. Output voltage is [IN+OFFSET] x 10
  5. "MON" port is a mirror of "OUT" port given by OUT / 100

Picture

#ref(): File not found: "PIdriver.jpg" at page "AndoLabInstruments1chPZTDriver"

Transfer Function

Output Noise


トップ   新規 一覧 検索 最終更新   ヘルプ   最終更新のRSS