AndoLabInstruments1chPZTDriver のバックアップ差分(No.3)

• バックアップ一覧
• 現在との差分 を表示
• ソース を表示
• バックアップ を表示
• AndoLabInstruments1chPZTDriver へ行く。
  • 1 (2021-11-13 (土) 20:33:46)
  • 2 (2021-11-15 (月) 20:03:39)
  • 3 (2021-11-15 (月) 20:05:07)

• 追加された行はこの色です。
• 削除された行はこの色です。

#author("2021-11-14T22:09:31+09:00","default:LabMember","LabMember")
#author("2021-11-15T20:05:07+09:00","default:LabMember","LabMember")
[[AndoLabInstruments]]

* 1ch PZT Driver [#i9ad571f]
- 20 dB PZT driver with 1 channel
- Main module is [[PI E-610>https://www.pi-japan.jp/ja/products/controllers-and-drivers/nanopositioning-piezo-controllers/e-610-piezo-amplifier-controller-601000/]]. 
This module is also used in [[6ch PZT Driver>AndoLabInstrumentsE610]]

** How to use [#n2dbcf3f]
+ Connect DC power. Default connector is HIROSE 4pin male (as usual) on the back panel. 6-30V DC power is acceptable (15V is desired).
+ Connect PZT to "OUT" port and apply the control voltage to "IN" port.  
+ Offset is variable by adjusting a potentiometer "OFFSET". 
+ Output voltage is [IN+OFFSET] x 10
+ "MON" port is a mirror of "OUT" port given by OUT / 100

** Picture [#kb74584f]
#ref(PIdriver.jpg,,20%);
- Front
#ref(PZTamp_front.jpeg,,10%);
-Inside
#ref(PZTamp_inside.jpeg,,10%);

** Transfer Function [#x3355914]
-Measured by S. Takano on 10/11/2021
#ref(PZTamp_TF.png,,20%);
- Gain is 20dB for OUT, -20dB for MON
- 2 poles at 9.8kHz

** Output Noise [#s5a08570]
-Measured by S. Takano on 10/11/2021
#ref(PZTamp_noise.png,,20%);