GUPPy のバックアップ(No.1)

• バックアップ一覧
• 差分 を表示
• 現在との差分 を表示
• ソース を表示
• GUPPy へ行く。
  • 1 (2019-07-15 (月) 02:24:43)
  • 2 (2019-07-15 (月) 03:20:45)
  • 3 (2019-11-16 (土) 18:26:44)

GUPPy - Graphical User interface for Picomotors by Python †

Back

Introduction †

GUPPy is a GUI for New Focus Ethernet Controller 8752. You can control, via a serial port, up to 6 picomotors (3 channels x 2 drivers). Serial communication is controlled by python and GUI is made by Jupyter widgets.
GUPPy was made by Satoru Takano. If you find any problems, please inform me.

Download †

A zip file is here.

Requirement †

First of all, you have to use Python 3.X. These python packages are also necessary:

• Jupyter notebook or Jupyter Lab
• ipywidgets
• pySerial

Installation †

If you satisfy all the requirements, you don't have to install anything else. Open the GUPPy.ipynb file and run it.

That's it!

Documentation †

A simple documentation "README.html" is under the unzipped folder.

A document for serial communication to the controller by CUI way may help you.