GUPPy - Graphical User interface for Picomotors by Python

GUPPy.png

Back

Introduction

GUPPy is a GUI for New Focus Ethernet Controller 8752. You can control, via a serial port, up to 6 picomotors (3 channels x 2 drivers). Serial communication is controlled by python and GUI is made by Jupyter widgets.
GUPPy was made by Satoru Takano. If you find any problems, please inform me.

Download

A zip file is here.

Requirement

First of all, you have to use Python 3.X. These python packages are also necessary:

Installation

If you satisfy all the requirements, you don't have to install anything else. Open the GUPPy.ipynb file and run it.

That's it!

Documentation

A simple documentation "README.html" is under the unzipped folder.

A document for serial communication to the controller by CUI may help you.

Change log

0.2

Change how to order to move. Remove 'Move' button and add 'Back' and 'Forward' button.

0.1

The first release of GUPPy.


添付ファイル: fileGUPPy_0.2.zip 408件 [詳細] fileGUPPy.png 848件 [詳細]

トップ   編集 凍結 差分 バックアップ 添付 複製 名前変更 リロード   新規 一覧 検索 最終更新   ヘルプ   最終更新のRSS
Last-modified: 2019-11-16 (土) 18:32:22