AndoLabInstrumentsE610 のバックアップ差分(No.2)

• バックアップ一覧
• 現在との差分 を表示
• ソース を表示
• バックアップ を表示
• AndoLabInstrumentsE610 へ行く。
  • 1 (2020-07-20 (月) 13:36:07)
  • 2 (2020-07-20 (月) 14:00:58)
  • 3 (2021-11-11 (木) 17:20:46)
  • 4 (2021-11-15 (月) 17:35:05)

• 追加された行はこの色です。
• 削除された行はこの色です。

[[AndoLabInstruments]]
* 6ch PZT Driver [#i9ad571f]
- 20 dB PZT driver with 6 channel
- Closed loop control is capable with an adequate actuator

** How to use [#n2dbcf3f]
This driver has 2 outputs, labelled with "PZT" and "MON". Connect "PZT" output to a PZT, and don't touch the other ports''. Especially, "T" port output high voltage even though there is no input, so if you connect "T" port to some instruments you may break it!
This driver has 2 outputs, labelled with "PZT" and "MON". Connect "PZT" output to a PZT, and connect "MON" output to an oscilloscope or a data logger. "MON" port outputs one hundredth of "PZT" port voltage. 

** Picture [#kb74584f]
#ref(PIdriver.jpg,,20%);
#ref(picture_PZTamp.jpg,,10%);

** Transfer Function [#x3355914]
-Measured by S. Takano in 26nd June 2020
#ref(DriverResponse_PI.png,,20%);
- Measured by Y. Oshima in 8th July 2020 
#ref(transfun_PZTamp.png,,50%);

** Output Noise [#s5a08570]
-Measured by S. Takano in 22nd June 2020
#ref(DriverNoise_PI.png,,20%);
- Measured by Y. Oshima in 8th July 2020
#ref(noise_PZTamp.png,,50%);

** Notice [#udc7998c]
- This driver has a notch at 120Hz and 1st order low-pass with cutoff frequency 120Hz. If you use this driver to control some system, you must consider these characteristics
- This driver has 1st order low-pass with cutoff frequency 400 Hz. This driver adds 10 V offset to output. The range of output voltage is from - 30 V to 110 V.