\BOOKMARK [0][-]{chapter.1}{1 Introduction}{}% 1 \BOOKMARK [1][-]{section.1.1}{1.1 Requirements}{chapter.1}% 2 \BOOKMARK [0][-]{chapter.2}{2 Optical Configuration}{}% 3 \BOOKMARK [1][-]{section.2.1}{2.1 Overview}{chapter.2}% 4 \BOOKMARK [1][-]{section.2.2}{2.2 Arm Cavity Parameters}{chapter.2}% 5 \BOOKMARK [2][-]{subsection.2.2.1}{2.2.1 Arm Cavity Higher Order Mode Resonances}{section.2.2}% 6 \BOOKMARK [2][-]{subsection.2.2.2}{2.2.2 RF Sidebands Resonances in the Arm Cavities}{section.2.2}% 7 \BOOKMARK [2][-]{subsection.2.2.3}{2.2.3 Parametric Instability}{section.2.2}% 8 \BOOKMARK [2][-]{subsection.2.2.4}{2.2.4 Angular Instability by the Radiation Pressure}{section.2.2}% 9 \BOOKMARK [2][-]{subsection.2.2.5}{2.2.5 Conclusion on g-factors}{section.2.2}% 10 \BOOKMARK [1][-]{section.2.3}{2.3 Recycling Cavities}{chapter.2}% 11 \BOOKMARK [2][-]{subsection.2.3.1}{2.3.1 Reflectivities}{section.2.3}% 12 \BOOKMARK [2][-]{subsection.2.3.2}{2.3.2 Length and RF SB frequencies}{section.2.3}% 13 \BOOKMARK [2][-]{subsection.2.3.3}{2.3.3 Radius of Curvature of the RC mirrors}{section.2.3}% 14 \BOOKMARK [1][-]{section.2.4}{2.4 Output mode-cleaner system}{chapter.2}% 15 \BOOKMARK [0][-]{chapter.3}{3 Length Sensing and Control Scheme}{}% 16 \BOOKMARK [1][-]{section.3.1}{3.1 Overview}{chapter.3}% 17 \BOOKMARK [1][-]{section.3.2}{3.2 Simulation Conditions}{chapter.3}% 18 \BOOKMARK [1][-]{section.3.3}{3.3 Signal Name Convention}{chapter.3}% 19 \BOOKMARK [1][-]{section.3.4}{3.4 Signal Extraction Ports}{chapter.3}% 20 \BOOKMARK [1][-]{section.3.5}{3.5 Loop Noise}{chapter.3}% 21 \BOOKMARK [2][-]{subsection.3.5.1}{3.5.1 Servo loop model}{section.3.5}% 22 \BOOKMARK [2][-]{subsection.3.5.2}{3.5.2 Feed forward}{section.3.5}% 23 \BOOKMARK [1][-]{section.3.6}{3.6 PD Dynamic Range}{chapter.3}% 24 \BOOKMARK [0][-]{chapter.4}{4 Noise Requirements}{}% 25 \BOOKMARK [1][-]{section.4.1}{4.1 Mirror Displacement Noise}{chapter.4}% 26 \BOOKMARK [1][-]{section.4.2}{4.2 Laser Noises}{chapter.4}% 27 \BOOKMARK [2][-]{subsection.4.2.1}{4.2.1 Frequency stabilization servo}{section.4.2}% 28 \BOOKMARK [2][-]{subsection.4.2.2}{4.2.2 Frequency noise requirement}{section.4.2}% 29 \BOOKMARK [2][-]{subsection.4.2.3}{4.2.3 Intensity noise}{section.4.2}% 30 \BOOKMARK [1][-]{section.4.3}{4.3 RF Oscillator Noises}{chapter.4}% 31 \BOOKMARK [2][-]{subsection.4.3.1}{4.3.1 Phase Noise}{section.4.3}% 32 \BOOKMARK [2][-]{subsection.4.3.2}{4.3.2 Amplitude Noise}{section.4.3}% 33 \BOOKMARK [1][-]{section.4.4}{4.4 Scattered Light Noise}{chapter.4}% 34 \BOOKMARK [2][-]{subsection.4.4.1}{4.4.1 Light power in the interferometer}{section.4.4}% 35 \BOOKMARK [0][-]{chapter.5}{5 Alignment Sensing and Control Scheme}{}% 36 \BOOKMARK [1][-]{section.5.1}{5.1 Overview}{chapter.5}% 37 \BOOKMARK [1][-]{section.5.2}{5.2 Soft and Hard Modes}{chapter.5}% 38 \BOOKMARK [1][-]{section.5.3}{5.3 Simulation Conditions}{chapter.5}% 39 \BOOKMARK [1][-]{section.5.4}{5.4 Signal Extraction Ports}{chapter.5}% 40 \BOOKMARK [1][-]{section.5.5}{5.5 Angular noise coupling to DARM}{chapter.5}% 41 \BOOKMARK [2][-]{subsection.5.5.1}{5.5.1 Structure of the ASC model}{section.5.5}% 42 \BOOKMARK [2][-]{subsection.5.5.2}{5.5.2 Simulation results}{section.5.5}% 43 \BOOKMARK [0][-]{chapter.6}{6 Lock Acquisition Scheme}{}% 44 \BOOKMARK [1][-]{section.6.1}{6.1 Overview}{chapter.6}% 45 \BOOKMARK [1][-]{section.6.2}{6.2 Green Laser Pre-Lock}{chapter.6}% 46 \BOOKMARK [2][-]{subsection.6.2.1}{6.2.1 Overview}{section.6.2}% 47 \BOOKMARK [2][-]{subsection.6.2.2}{6.2.2 Noise Analysis}{section.6.2}% 48 \BOOKMARK [2][-]{subsection.6.2.3}{6.2.3 Third Harmonics Demodulation}{section.6.2}% 49 \BOOKMARK [1][-]{section.6.3}{6.3 Non-Resonant Sideband for Lock Acquisition}{chapter.6}% 50 \BOOKMARK [0][-]{chapter.7}{7 Optical Layout}{}% 51 \BOOKMARK [1][-]{section.7.1}{7.1 Basic design}{chapter.7}% 52 \BOOKMARK [1][-]{section.7.2}{7.2 Wedge angle error tolerance}{chapter.7}% 53 \BOOKMARK [1][-]{section.7.3}{7.3 Tunnel Slope}{chapter.7}% 54 \BOOKMARK [0][-]{chapter.8}{8 Installation/Adjustment Procedure}{}% 55 \BOOKMARK [0][-]{chapter.9}{9 iKAGRA}{}% 56 \BOOKMARK [1][-]{section.9.1}{9.1 Overview}{chapter.9}% 57 \BOOKMARK [1][-]{section.9.2}{9.2 Changes from bKAGRA}{chapter.9}% 58 \BOOKMARK [2][-]{subsection.9.2.1}{9.2.1 Mirrors}{section.9.2}% 59 \BOOKMARK [2][-]{subsection.9.2.2}{9.2.2 Optical Layout}{section.9.2}% 60 \BOOKMARK [2][-]{subsection.9.2.3}{9.2.3 Mode Matching}{section.9.2}% 61 \BOOKMARK [2][-]{subsection.9.2.4}{9.2.4 Interferometer Control}{section.9.2}% 62 \BOOKMARK [0][-]{appendix.A}{A Recycling Cavity Length Determination Algorithm}{}% 63 \BOOKMARK [0][-]{appendix.B}{B SRCL non-linearity}{}% 64 \BOOKMARK [0][-]{appendix.C}{C Mixed PM and AM for f1}{}% 65 \BOOKMARK [0][-]{appendix.D}{D Terminology}{}% 66 \BOOKMARK [0][-]{appendix.E}{E Contributors}{}% 67